H1102NL以太网变压器IC

Ethernet is a wired networking technology that makes use of twisted pair differential cables to transfer data at high bitrates. Because of the distances over which it can be transported, various effects like static charge and common mode noise are picked up. To prevent this from affecting the transmitting and receiving circuits, a component called anethernet transformeris used. The H1102NL is one such变压器, containing a pair of magnetics inside for both transmitting and receiving sections as well as common mode protection.

H1102NL Pinout Configuration

Pin Number	Pin Name	Description
1, 2, 3	变压器1输入	Signal input pins for the first transformer
6, 7, 8	变压器2输入	Signal inputs for the second transformer
15	变压器1常见	Secondary common for the first transformer
10	Transformer 2 common	Secondary common for the second transformer
16, 14	Transformer 1 outputs	Signal output pins for the first transformer
11，9	Transformer 2 outputs	Signal output pins for the second transformers

Features and Specifications

• Dual transmit/receive magnetics
• Conforms to IEEE802.3 specification
• Compact footprint

Note:Complete technical details can be found in theH1102NL数据表given at the end of this page.

H1102NL Equivalents

H1183NL, H1199NL

Other

H11XX Series

How To Use H1102NL?

The Ethernet protocol uses differential signaling, i.e. instead of one signal and one reference wire, two wires are used, whose states are complementary to each other, as shown in the figure below. This makes the signal more immune to common-mode noise.

Ethernet cables are usually run over long distances. This increases the chance of picking up noise from mains, high-frequency switching converters, and other sources of electromagnetic noise. The plastic insulating cable can also generate static charges, which can result in harmful high-voltage arcing which can damage the transmitting and receiving electronics.

For this reason, an isolating transformer is used on both the transmitting and receiving sides of the circuit. The primary side has two windings that share a common terminal. The middle terminal is connected to V_DDin case the transmitting IC has open-drain outputs, and is left floating in case of push-pull outputs. Each of the outer pins is connected to the differential negative and positive outputs of the transmitting IC. A similar scheme is followed on the secondary side, but the center tap is connected to either ground or a reference voltage that is generated on the receiving side.

There is also a coupled inductor on the secondary side that acts as a common mode choke, which blocks signals related to earth ground but lets differential signals pass through.

申请

• Ethernet LAN, MAN, and WAN networks
• 坡(对以太网)

2D Model and Dimensions

If you are designing a PCB or Perf board with this component then the following picture from the Datasheet will be useful to know its package type and dimensions.