INA333 Instrumentation Amplifier

2019年12月2 - 0 Comments

INA333 Amplifier IC

INA333 Pinout

The INA333 device is a low-power, precision instrumentation amplifier offering excellent accuracy. The versatile 3-operational amplifier design, small size, and low power make it ideal for a wide range of portable applications.

Pin Description of INA333:

Pin Number	Pin Name	Description
1	Gain (Rg)	Inverting Gain Terminal connected to a resistor to set gain value
2	Inverting Input (IN-)	The Inverting input pin of the Op-Amp
3	Non- Inverting Input (IN-)	The Non - Inverting Input Pin of Amplifier
4	Power (-Vs)	负supply terminal
5	Reference	Output reference input. Normally connected to common
6	Output	Amplifier output pin
7	Power (+Vs)	Positive supply terminal
8	Gain (Rg)	Non - Inverting Gain Terminal connected to a resistor to set gain value

LM623 features and specifications:

Rail to Rail Instrumentation Amplifier
Number of Channels: 1 Channel
Operating Supply Voltage:5.5 V
SR - Slew Rate: 0.16 V/us
CMRR - Common Mode Rejection Ratio:100 dB
Ib - Input Bias Current:1.4nA
Vos - Input Offset Voltage:10uV
Operating Supply Current: 198uA
Bandwidth:150 kHz
Gain V/V:1000 V/V
Available in 8-Pin PDIP, SOIC, and VSSOP packages

Note:Complete Technical Details can be found at theINA333 datasheetgive at the end of this page.

Equivalent for INA333:AD623

Alternatives Instrumentaion Amplifiers:LM4871, AD620, IC6283, JRC4558

Where to use the INA333 Instrumentation Amplifier?

The INA333 is an Instrumentation Amplifier withRail to Rail feature. It also operates at a very low current making it suitable forbattery-operated applications. An instrumentation amplifier is a type of differential amplifier that has buffer amplifiers connected to their input pins. This eliminates the need for impedance matching, thus making it practically suitable formeasurement and test equipment.

How to use INA333:

The INA333 only requires a resistor to sets its gain value and hence can be easily set up. A very basic commonly used circuit for INA333 is shown below.

INA333 Circuit Diagram

The IC is powered using pin 7 and pin 4 is connected to ground. Here I have used a single supply of +5V. The non - inverting pin (pin 2) and the inverting pin (pin 3) are connected to the signal which has to be amplified or compared base on the application of the Op-Amp. The Reference pin (pin 5) is normally grounded along with pin 4, the reference pin is used to direct the output towards a voltage when the difference voltage between the inverting and the non-inverting pin is 0V.

一个运放的增益可以通过简单地连接设置ing the right value of the resistor across the pin +Rg (pin 8) and the pin –Rg (pin 1). Here I have connected a resistor of value 500Ω which will set the Op-Amp at a gain value of 100. The formulae to calculate the value of gain from R is given below.